Fonts to choose from. Some fonts will not be available with some size options. If you don't see the font you want, increase your size option.
Also the size you choose is the overall width of the decal (All Text Combined) NOT the height of the letters.
You should read these instructions all the way through before starting. The surface must be clean, and free of all oils, waxes and dirt. We suggest using Cleaners such as Windex or we recommend 1 part isopropyl alcohol to 5 parts mixture of water. If you use rainx, try formula 409 to remove it. Once the surface has been cleaned take a lint free towel and wipe down any extra liquid. These decals come to you in three layers. The top layer is called transfer tape. It looks somewhat like regular masking tape. The middle layer is the actual decal. The bottom layer is a backing paper that the decal will peel off of once applied to the surface. Since our decals are adhesive based it highly recommendable to apply your decals in a temperature over 55 degrees Fahrenheit, if you are needing to warm up the area a blow dryer or heat gun will work perfectly.
Once the Decal touches the glass or paint, it cannot be moved again!
Appling Small to Medium Decals – Sizes 4” – 8”
1. Place sticker face up on table or hard surface. Use squeegee, credit card or driver’s license. Rub over surface. This will ensure the decal will stick to application tape when removing the backing.
2. Clean surface (outside of window) using window cleaner and preferably alcohol. Allow to dry.
3. Leaving the decal face down carefully & slowly remove backing. If some of decal sticks to backing, re-attach and repeat step 1.
4. Apply decal from inward to outward. Once your decal touches the surface it will stick so you will want to ensure your decal is on straight. We suggest you mark the area with a piece of tape or removable marker.
5. With a squeegee, credit card or driver’s license, rub once Again. This will ensure decal will stay on window (or surface area applying it to) and all air bubbles have been removed.
6. Carefully remove application tape. Pull the tape back over itself. If bubbles appear, squeeze them out to the edge using a credit card or firm edge squeegee.
Wet Transfer Method: Decals sizes 10" and larger
1. Clean surface (outside of window) using window cleaner or preferably alcohol. Wipe surface with a lint free rag or towel.
2. Have your spray bottle with water only ready.
3. Place decals face down on flat surface and separate the backing paper from the adhesive (side with decal) pull up a corner of the backing tape take a piece of tape and place on the one corner pull the backing paper away from the adhesive (side with decal). Pull the backing paper back directly upon itself at an angle of 180°. As you begin pulling the backing paper back, begin to spray the exposed adhesive (side with decal) with the water using the spray bottle. Be careful to not allow dirt or other contaminants to get on the adhesive (side with decal). Do not let the adhesive touch anything but the glass on which is to be installed.
4. Spray the entire surface of the glass with the water using the spray bottle.
5. Position the decal onto the glass. Beginning in the center and top of the decal, squeegee the wet application fluid and air from underneath the surface of the decal to the right edge of the glass. Now squeegee from the center and top of the decal to the left edge of the glass. Always squeegee the trapped air and water to the nearest edge.
6. Once you have removed the trapped air and the water you want to carefully remove the application tape, pull the tape back over itself. This will leave only your decal on the surface.